![]() That said, if you put castors on the two middle desk side positions and feet on the chair side, I think you should be able to fold normally. I normally just wheel it to one side of my desk. I'm pretty sure if I fold my set up, the wheels and the feet would clash and prevent closing fully (I'm not going to test it as I have a heavy shifter and hand brake on one side, which makes folding an exercise in not dropping the damn thing on my feet as it tries to fall over to that side …). You can turn the pot to a certain position and mount the pot back in the pedal and recalibrate (set max and min) and then youre good to go. This doesnt happen in other games like F1 or Assetto. I am using ps4 DD1 with 1st gen clubsport pedals. Some time it very quick, nut still slows me down, other times its a killer and stays on for a-second or so. My guess is that the unused range of the pot has no wear and tear so the carbon strip inside is intact. While Im racing the E brake light keeps flashing. Alternative D-shape race plates in curved design. You can monitor the range currently in use by using the Fanatec Software. 12bit resolution (4096 values) on all axis. Adjustable brake stiffness and travel without tools. Mi pedals are connected straight to my Clubsport 2.5 base, and I have the CSL P1 XBOX wheel. Had it in Hard config, I changed to MEDIUM cause I was unable to reach 100 of brake pressure but, I cant do it yet. Pressure sensitive brake with custom made 90 kg load cell sensor. Hi guys, I have the Clubsport V3 pedals with the Performance Kit. However, I did like the looks of the castors linked by Xenoic below - I was just too stupid to realise I could switch out the bolt (which would have been much better than buying the NLR set) - so that's probably a better solution. High resolution pedals with magnetic and contactless sensors on gas and clutch for a long life and maximum performance. If you do go this path, take an M8 nut along to test the fit - too loose and you may have problems later). I saw the ones you linked, but wasn't prepared to deal with the 5/16-M8 mismatch (engineering background - do it properly or not at all. ![]() Games vary quite a bit so in game always start by lowering the Brake Pressure. Set BrF to 90 to start as this will require more pressure to achieve full lock. Set Min also while resting your foot on the brake lightly. The only M8s I could find were either ugly or looked flimsy. Depress the Brake fully with a good amount of pressure and set Max point. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |